MEN MICRO Industrial Partner

ESM Starter Kit with Tualatin Pentium III Simple Type: CPU Board

Embedded System Modules are complete computers on a module. A final ESM-based embedded application consists either of a stand-alone ESM (the power supply connection being sufficient to operate the module), an ESM with an application-specific carrier card and/or an ESM with additionally plugged PCI-104 modules. The EK01 is a ready-to-use starter kit that allows evaluation of the functions of the EM02 Embedded System Module. The kit consists of the standard CPU module, DRAM memory, the carrier card with I/O connectors, an external PSU, and an adapter for mounting a PCI-104 module. The EK01 provides versatile mounting options and can also be installed in a standard PC (including a PCI-104 module). After evaluation, the design overhead for each application is limited to I/O. Depending on the application and quantity it may be necessary to develop a simple carrier card, choose PCI-based standard components, write software drivers for those additional functions, or design a housing. This minimal additional design effort can be carried out by the user or by MEN. The EM02 is an ideal computing platform for embedded industrial PCs under Windows or Linux. It is controlled by an Ultra-Low Power Tualatin Pentium III with 933MHz or an Ultra-Low Voltage Tualatin Celeron Processor with 400MHz. It provides 16KB L1 and 512KB/256KB L2 cache. The EM02 uses the Intel 815G chip set, including graphics. It provides one VGA connector, one USB 1.1 connector Type A and one Gigabit Ethernet interface at the front panel. It also provides 512MB of DRAM and a CompactFlash slot on board. As an alternative to onboard USB, legacy I/O is routed to the carrier board via the J2 system connector of the EM02. It includes a serial interface, (E)IDE, a floppy interface, as well as two PS/2 interfaces for keyboard and mouse. The carrier board has an ATX-compatible format and provides the mechanical platform, the power supply and the I/O connectors. It comes with one ESM slot and three PCI slots, which allow the use of standard extension cards in the PC. It is equipped with USB 2.0 (front), a 9-pin D-Sub for an RS232 serial interface (front) and connectors for IDE and floppy. The ESM carrier also features an I2C EEPROM for the board ID and revision information. DVI/TFT/video are not supported on the EK01 kit but are available on the EM02 itself for implementation as a hub interface on other (custom) carrier cards.

Download the datasheet (PDF)